Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell PowerEdge T330 Owner's Manual

Installing the LCD module

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. Keep the Phillips #2 screwdriver ready.

Steps

  1. Align the LCD module with the LCD module slot and insert the LCD module into the control panel.
  2. Tighten the screw to secure the LCD module to the control panel.
  3. Insert the LCD module cable into it’s connector on the control panel board and push the retention tab in to secure the cable.
    Figure 1. Installing the LCD Module
    This figure shows installing the LCD module.
    1. LCD module
    2. retention tab
    3. LCD cable connector
    4. LCD cable
    5. screw

Next steps

  1. Install the control panel assembly cover.
  2. Connect the LCD cable, the control panel cable, and the control panel USB cable to the control panel board.
  3. Install the control panel assembly.
  4. Connect the control panel cable, the LCD cable, and the control panel USB cable to the system board.
  5. Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\