Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge T330 Owner's Manual

PDF

Installing a cabled power supply unit

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Unpack the replacement power supply unit (PSU).

Steps

  1. Slide the new PSU into the PSU cage until the PSU is fully seated.
  2. Tighten the screw to secure the PSU to the chassis.
  3. Connect all the power cables from the PSU to the system board, hard drive backplane, hard drives, and optical drives.
    Figure 1. Installing a cabled PSU
    This figure shows installing a cabled PSU.
    1. screw
    2. PSU cage
    3. non-redundant PSU
    4. standoff on the chassis
    5. P2 power cable connector
    6. P1 signal cable connector
    7. P1 power cable connector
    8. P4/backplane connector

Next steps

Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\