Aurora R7 Setup and Specifications

PDF

Set up your computer

  1. Connect the keyboard and mouse.
    Image: Connect the keyboard and mouse
    NOTE:For setup instructions, see the documentation shipped with the keyboard and mouse.
  2. Connect the network cable — optional.
    Image: Connect the network cable
  3. Connect the display.
    Image: Connect the display
    NOTE: The DisplayPort on the back panel of your computer is covered. Connect the display to the discrete graphics card of your computer.
    NOTE: If you have two graphics cards, the card installed in PCI-Express X16 (graphics slot 1) is the primary graphics card.
    NOTE:For more information about setting up multiple monitors, see the knowledge base article SLN129825 at https://www.dell.com/support.
  4. Connect the power cable.
    Image: Connect the power cable
  5. Press the power button.
    Image: Press the power button

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\