Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In

Dell Lifecycle Controller Integration Version 3.3 for Microsoft System Center Configuration Manager Installation Guide

PDF

Installing DLCU and DPS

About this task

To install the DLCU and DPS on a site server or Admin Console:

Steps

  1. From Custom Setup, select both Dell Lifecycle Controller Utility and Dell Provisioning Service and click Next. The Custom Setup Confirmation screen is displayed.
  2. Click Next. The Dell Provisioning Service User Credentials for Configuration Manager Access screen is displayed.
  3. Perform one of the following:
    1. On a site server, enter an account (with required privileges) for use by Dell Provisioning Service to access Configuration Manager on all newly discovered systems with iDRAC, and click Next.
    2. On a Configuration Manager Admin Console with IIS, type the primary site server name, user name, and password that is provisioned on all newly discovered systems with iDRAC, and click Next. To automatically configure the Dell Provisioning Server, select Automatically configure Dell Provisioning Server user permissions .
    The Dell Lifecycle Controller Utility User Credentials for iDRAC Access screen is displayed.
  4. Type the iDRAC credentials, retain the default settings for skipping CN and CA checks, and then click Next. The Change Firewall Setting screen is displayed.
  5. Select the Add Provision Web Site Port in the firewall exception list option. This option enables the DPS to discover the target systems even when firewall is enabled.
    • NOTE: This screen is displayed only when you select the Dell Provisioning Service in the installer.
  6. Click Next. The Ready to Install the Program window is displayed.
  7. Click Install. The Progress bar is displayed. After installation, the completion message is displayed.
  8. Click Next.
  9. In Installation Completed Successfully, click Finish.
    • NOTE: As part of the installation, a provisioning website is created and configured under Internet Information Services (IIS).

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\