Dell Update Packages Version 14.11.201 User's Guide

PDF

Messages

For descriptions and solutions to messages that you may receive when running DUPs, see the following table. Also see the corresponding Readme for Microsoft Windows at dell.com/support/manuals.

Table 1. Messages
Message	Description/Solution
This Update Package is not compatible with your system. Your system: <system model name>	Select a compatible DUP, and try the update again.
This Update Package is not compatible with your system. Your system: <system model name> Systems(s) supported by this package: <system model name>...: <system model name>	Select a compatible DUP, and try the update again.
This Update Package cannot be executed under the current operating system.	The operating system is not supported by DUP. For a list of supported operating system check the Dell Systems Software Support Matrix. This document is available at dell.com/support/manuals.
Your system does not have the minimum operating system version or service pack required for this Update Package.	The DUP you selected cannot be installed because the minimum operating system version or service pack requirements were not met. Install the appropriate version, and try the update again. Or, use an alternate update method on dell.com/support/manuals.
Your system exceeds the maximum operating system version supported by this Update Package.	The DUP you selected cannot be installed because the system exceeded the maximum operating system version supported by the DUP. Install the appropriate version or select another DUP, and try the update again.
This Update Package is not compatible with any of the devices detected in your system.	Select a compatible DUP for the device(s) you want to update, and try again.
The prerequisite software version for this update was not found: Software application name: <name> Current version: <version> Required version: <version>	The DUP you selected cannot be installed because a prerequisite requirement was not met. Install the appropriate prerequisite software version, and try the update again.
The software to be updated was not found. Install the following software, and then retry the update. Software name: <name> Required version: <version>	The system does not contain the software that matches the DUP.
The version of this Update Package is newer than the currently installed version. Software application name: <name> Package version: <version> Installed version: <version>	This message confirms the version of the currently installed software before the update is performed.
The version of this Update Package is older than the currently installed version. Software application name: <name> Package version: <version> Installed version: <version>	The DUP you selected cannot be installed because a newer version of the software already exists on the system. To install the older version: In the interactive mode , Click Yes when prompted to continue with the installation. In the CLI mode Specify the /f option.
The version of this Update Package is the same as the currently installed version. Software application name: <name> Package version: <version> Installed version: <version>	The DUP you selected cannot be installed because the same version of the software already exists on the system. In the interactive mode , Click Yes when prompted to continue with the installation.
This package is not compatible with the version of Server Agent on your system. You must upgrade to Server Administrator before running this package.	Use an alternative update method from dell.com/support/manuals.
Administrator privileges are required to perform this update.	Log in with Administrator privileges, and try the update again.
You must reboot the system for the update to take effect.	If you shut down or power off the system after performing an update, you will lose the update.
An Update Package is already running. Wait until it is complete before proceeding with another update.	You can run only one DUP at a time.
This Update Package is not installed. Software application name: <name> Package version: <version> Would you like to install?	In an interactive mode, if a fresh install is applicable, you are presented with a choice to install or not. The package version is also displayed.