Alienware 17 R4 Service Manual

Procedure

1. Connect the tron-light cables, the logo-board cable, and the Alienhead cable to the logo board.
2. Push the latch that secures the Alienhead cable to the logo board.
3. Turn the logo board over.
4. Using the alignment post, place the logo board on the display back-cover and antenna assembly.
5. Align the screw holes on the logo board with the screw holes on the display back-cover and antenna assembly.
6. Replace the two screws (M2x3) that secure the logo board to the display back-cover and antenna assembly.