Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge FC430 Owner's Manual

PDF

Installing the LOM riser card

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
NOTE: You must remove the LOM riser card to replace a faulty LOM riser card or service other components inside the system.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.

  3. Keep the Phillips #2 screwdriver ready.

Steps

  1. Align the screw holes on the card with the standoffs on the system board.
    CAUTION: To prevent damage to the LOM riser card, you must hold the card only by its edges.
  2. Press the card into place until the card connector fits into the corresponding connector on the system board.
  3. Secure the card with the two screws.
    Figure 1. Installing the LOM riser card
    This image shows installing the LOM riser card.
    1. LOM riser card
    2. screw (2)
    3. standoff (2)
    4. connector on the system board

Next steps

Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\