The software security features of sled include
a system password and a setup password. The password jumper enables
these password features or disables them, and clears any password(s)
currently in use.
CAUTION: Many
repairs may only be done by a certified service technician. You should
only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by
Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
Turn off the sled using the operating system
commands or the CMC.
Remove the sled from the enclosure to access
the jumpers.
Move the jumper on the system-board jumper
from pins 1 and 2 to pins 2 and 3.
Install the sled in the enclosure.
Turn on the sled.
When the sled is turn on, power indicator turns
on to solid green. Allow the sled to finish booting.
The existing passwords are not disabled (erased) until the system
boots with the password jumper on pins 2 and 3.
Turn off the sled using the operating system
commands or the CMC.
Remove the sled from the enclosure to access
the jumpers.
Move the jumper on the system-board jumper
from pins 2 and 3 to pins 1 and 2.
Install the sled in the enclosure.
Turn on the sled.
Assign a new system and/or setup password.
Los datos no están disponibles para el tema
Proporcione calificaciones (1 a 5 estrellas).
Proporcione calificaciones (1 a 5 estrellas).
Proporcione calificaciones (1 a 5 estrellas).
Seleccione si el artículo fue útil o no.
Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"