Omitir para ir al contenido principal
Cerrar

Bienvenido a Dell

Mi cuenta
  • Hacer pedidos rápida y fácilmente
  • Ver pedidos y realizar seguimiento al estado del envío
  • Cree y acceda a una lista de sus productos
  • Administre sus sitios, productos y contactos de nivel de producto de Dell EMC con Administración de la empresa.
Iniciar sesión Crear una cuenta Clientes Premier Iniciar sesión en el programa para partners
Contáctenos

Dell PowerEdge R730 Owner's Manual

PDF

Installing a heat sink

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. Remove the cooling shroud.
  4. Install the processor.
  5. Keep the Phillips #2 screwdriver ready.

Steps

  1. If you are using an existing heat sink, remove the thermal grease from the heat sink by using a clean lint-free cloth.
  2. Use the thermal grease syringe included with your processor kit to apply the grease in a thin spiral on the top of the processor.
    CAUTION: Applying too much thermal grease can result in excess grease coming in contact with and contaminating the processor socket.
    NOTE: The thermal grease syringe is intended for one-time use only. Dispose of the syringe after you use it.
    Figure 1. Applying thermal grease on the top of the processor
    This figure shows applying thermal grease on the top of the processor.
    1. processor
    2. thermal grease
    3. thermal grease syringe
  3. Place the heat sink onto the processor.
  4. Tighten one of the four screws to secure the heat sink to the system board.
  5. Repeat the procedure for the remaining two screws.
    Figure 2. Installing the heat sink
    This figure shows installing the heat sink.
    1. retention screw (4)
    2. heat sink
    3. processor shield
    4. retention screw slot (4)
    Figure 3. Installing the 165 W heat sink
    This figure shows installing the 165 W heat sink.
    1. heat sink
    2. retention screw (4)
    3. processor shield
    4. retention screw slot (4)

Next steps

  1. Follow the procedure listed in the After working inside your system section.
  2. While booting, press F2 to enter System Setup and verify that the processor information matches the new system configuration.
  3. Run the system diagnostics to verify that the new processor operates correctly.

Califique este contenido

Preciso
Útil
Fácil de comprender
¿Este artículo fue útil?
0/3000 characters
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Seleccione si el artículo fue útil o no.
  Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"