- Notes, cautions, and warnings
- Introduction
- Advantages of using Lifecycle Controller
- Benefits of using iDRAC with Lifecycle Controller
- Key features
- New in this release
- Advantages of using Lifecycle Controller Remote Services
- Licensable features in Lifecycle Controller
- About iDRAC RESTful API with Redfish and Web Service APIs
- About Lifecycle Controller API
- About one-to-many management achieved
- Other information that you may need
- Accessing documents from the Dell EMC support site
- Contacting Dell
- Remote Services Features
- Deployment and configuration
- Monitor
- Maintain
- Job management
- Getting started with API collateral and links
- Integrating the Lifecycle Controller API
- Social media reference
- Terms and definitions
Dell Lifecycle Controller Remote Services v2.60.60.60 Quick Start Guide
Event alerts
Alerts and actions can be set for certain events that occur on a managed system. An event occurs when the status of a system component has changed to the predefined condition. If an event matches an event filter and this filter is configured to generate an alert (email, SNMP trap, or IPMI alert), an alert is sent to one or more configured destinations. If the same event filter is also configured to perform an action (such as reboot, power cycle, or power off the system), the action is performed. You can set only one action for an event.
Proporcione calificaciones (1 a 5 estrellas).
Proporcione calificaciones (1 a 5 estrellas).
Proporcione calificaciones (1 a 5 estrellas).
Seleccione si el artículo fue útil o no.
Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"