Dell NetWorker 19.10 Update Guide

PDF

Pre-processing and post processing script changes

NetWorker 9.0.1 and later does not support the savepnpc command.

After you update the NetWorker server, clients that use savepnpc command to perform backups will fail to backup. Modify these client resources to customize the backup behavior by running pre processing and post processing commands. An error message similar to the following appears in the savepnpc.log file: pstclntsave: RAP query returned NULL worklist.

To backup these clients in NetWorker 9.x, edit the Client resource, and perform the following steps:

  • In the Backup command attribute, remove the savepnpc command.
  • In the Pre command attribute, type the name of the script file that contains the commands to run before the start of the backup.
  • In the Post command attribute, type the name of the script file that contains the commands to run after the backup completes.
The section "Backup command customization: in the NetWorker Administration Guide provides more about the Pre command and Post command attributes and how to configure a client that requires pre processing and post processing commands.
Table 1. NetWorker Server VersionsNetWorker Server Versions
NetWorker Server Versions NetWorker client version configures with the NetWorker Server Client properties need to be updated
8.2.x 8.2.x backup command savepnpc
9.x and later 8.2.x backup command savepnpc
9.x and later 9.x and later pre command and post command

Évaluez ce contenu

Précis
Utile
Facile à comprendre
Avez-vous trouvé cet article utile ?
0/3000 characters
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez indiquer si l’article a été utile ou non.
  Les commentaires ne doivent pas contenir les caractères spéciaux : <>()\