Mounting Wyse
5010, Wyse 5020, and Wyse 5060 clients
Use the following instructions to attach the client
to the P-series mount.
Preparing
the client
—Use a Phillips-head screwdriver to remove the four
filler screws from the side of the client.
Attaching
the client
—Install the thin client on the P-series mount with
the M4.07-6 screws included in the tool kit.
NOTE: The power
button should face outwards and air vents should be on top end for
proper heat dissipation.
Attaching the power adapter holder—Slide
the small hooks downward into the vertical slotted holes and the large
hooks onto the top edge of the mount. Use the M2.5x0.45 screw to secure
the power adapter holder onto the mount as indicated in the following
illustration.
Removing the monitor stand
Place the
monitor panel face down on a soft cloth or cushion.
Remove the
stand from the monitor by pushing the monitor’s quick release button
as indicated in the following illustration.
Attaching
P-series mount to the monitor
Remove the
monitor screws from the back of the monitor, and use them when you
proceed with installation later.
Position
the P-series mount on the back of the monitor. Tilt and slide the
top tabs into the dedicated tab slots, and then firmly slide down
bottom edge of mount until it snaps in place.
Reinstall the monitor screws.
CAUTION: Do not
over-tighten the screws.
Reinstalling the monitor stand—Insert
the upper stand tabs into the dedicated space on the P-series mount
and gently press down until the quick release button snaps into place.
Place the monitor in the upright position.
Adjusting
and securing monitor height (optional)
For portrait
orientation-Raise the monitor to the maximum height and attach the
stopper. Ensure that the arrow on the stopper is facing up and facing
front side of the stand. Wrap the stopper around the stand and snap
the ends.
For landscape
orientation-Adjust the monitor height and attach stopper. Ensure that
the arrow on the stopper is facing up and facing front side of the
stand, and then snap the stopper ends.
NOTE:
The
stopper is required for P-series monitors to hold the monitor in place
at the desired height.
Connecting
cables
—To complete the setup, make all the desired connections,
and then plug in the power adapter to an electrical outlet.
Les données de cette rubrique ne sont pas disponibles
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez indiquer si l’article a été utile ou non.
Les commentaires ne doivent pas contenir les caractères spéciaux : <>()\