Utilities affected
by log off, restart, and shut down
The following utilities are affected by logging
off, restarting, and shutting down the thin client device:
Unified Write Filter—After
you turn on the system, the Unified Write Filter utility starts automatically.
Dell recommends you to use the UWF as described in the Microsoft documentation.
For more information, see www.microsoft.com, and navigate to the Unified Write Filter documentation.
NetXClean Utility—NetXClean
is a clean-up utility that keeps extraneous information from being
stored on the flash memory. Clean-up is triggered automatically on
restart, shut-down, or user log-off. If you want to keep certain profile
configurations, for example, printers, configure the NetXClean to
refrain from cleaning up any number of explicitly declared profiles.
For more information about NetXClean, see Before
configuring your thin clients, and Understanding
the NetXClean utility.
Power Management—A Monitor
Saver turns off the video signal to the monitor, allowing the monitor
to enter a power-saving mode after a designated idle time. To access
the power settings, go to Start > Control Panel > Power Options.
Wake-on-LAN—This feature discovers
all thin clients connected to your LAN, and enables you to wake them
by clicking a button. For example, to perform image updates and remote
administration functions on devices that have been shut down or are
on standby. To use this feature, the thin client power must be turned
on.
Les données de cette rubrique ne sont pas disponibles
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez indiquer si l’article a été utile ou non.
Les commentaires ne doivent pas contenir les caractères spéciaux : <>()\