- Notes, cautions, and warnings
- Before working inside your computer
- After working inside your computer
- Removing the base cover
- Replacing the base cover
- Removing the battery
- Replacing the battery
- Removing the solid-state drive
- Replacing the solid-state drive
- Removing the wireless card
- Replacing the wireless card
- Removing the speakers
- Replacing the speakers
- Removing the coin-cell battery
- Replacing the coin-cell battery
- Removing the heat sink
- Replacing the heat sink
- Removing the battery-status light cable with microphones
- Replacing the battery-status light cable with microphones
- Removing the touchpad
- Replacing the touchpad
- Removing the I/O-board cable
- Replacing the I/O-board cable
- Removing the I/O board
- Replacing the I/O board
- Removing the display assembly
- Replacing the display assembly
- Removing the display hinge cover
- Replacing the display hinge cover
- Removing the antenna
- Replacing the antenna
- Removing the system board
- Replacing the system board
- Removing the power-adapter port
- Replacing the power-adapter port
- Removing the fan
- Replacing the fan
- Removing the keyboard
- Replacing the keyboard
- Removing the palm-rest assembly
- Replacing the palm-rest assembly
- Downloading drivers
- System setup
- Troubleshooting
- Getting help and contacting Dell
Bienvenue
Bienvenue dans l’univers Dell
Mon compte
- Passer des commandes rapidement et facilement
- Afficher les commandes et suivre l’état de votre expédition
- Créez et accédez à une liste de vos produits
- Gérer vos sites, vos produits et vos contacts au niveau des produits Dell EMC à l’aide de la rubrique Gestion des informations de l’entreprise.
XPS 13 Service Manual
Procedure
- Slide the I/O board at an angle and then align the screw holes on the I/O board with the screw holes on the palm-rest assembly.
- Adhere the tape that secures the I/O board.
- Align the screw hole on the display cable with the screw hole on the I/O board.
- Replace the two screws (M1.6x3) that secure the I/O board to the palm-rest assembly.
- Slide the I/O-board cable into the I/O board and close the latch to secure the cable.
- Slide the fingerprint-reader cable (optional) into the I/O board and close the latch to secure the cable.
- Connect the media-card reader cable to the connector on the I/O board.
- Adhere the tape that secures the display cable to the I/O board.
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez indiquer si l’article a été utile ou non.
Les commentaires ne doivent pas contenir les caractères spéciaux : <>()\