Passer au contenu principal
  • Passer des commandes rapidement et facilement
  • Afficher les commandes et suivre l’état de votre expédition
  • Créez et accédez à une liste de vos produits
  • Gérer vos sites, vos produits et vos contacts au niveau des produits Dell EMC à l’aide de la rubrique Gestion des informations de l’entreprise.

Dell Storage with Microsoft Storage Spaces Cabling Guide

PDF

Server and enclosure port numbering

The following figures show the enumeration of the ports on the HBAs within the server.
Figure 1. Rear view of DSMS 630 server showing location of HBA ports This image shows rear view of DSMS 630 server showing location of HBA ports.
Figure 2. Rear view of DSMS 730 server showing location of HBA ports This image shows the rear view of DSMS 730 server showing location of HBA ports.
  • NOTE: Dell does not support having HBAs located in the lower two, full-height, PCI slots (slots 5 and 7).
The following figures show the enumeration of the ports on the HBAs within the storage enclosure.
Figure 3. Rear view of DSMS 3060e storage enclosure showing location of HBA ports This image shows rear view of DSMS 3060e storage enclosure showing location of HBA ports.
Figure 4. Rear view of DSMS 1400 series storage enclosure showing location of HBA ports This image shows rear view of DSMS 1400 series storage enclosure showing location of HBA ports.
Use these figures as a point of reference when cabling the storage enclosures to the servers. The SAS HBAs installed in the servers in your solution may not always match the figures displayed here. However, the same cabling guidance is applicable.
  • NOTE: When you view the back of a server, HBA ports are numbered left to right, and then top to bottom.

Évaluez ce contenu

Précis
Utile
Facile à comprendre
Avez-vous trouvé cet article utile ?
0/3000 characters
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez indiquer si l’article a été utile ou non.
  Les commentaires ne doivent pas contenir les caractères spéciaux : <>()\