Complete the following steps to set up your system:
Steps
Unpack the server module.
Remove the I/O connector cover from the server module connectors.
CAUTION: While installing the server module, ensure that it
is properly aligned with the slot on the enclosure to prevent damage
to the server module connectors.
Install the server module in the enclosure.
Turn on the enclosure.
NOTE: Wait for the chassis to initialize before you press the power button.
Turn on the server module by pressing the
power button on the server module.
Alternatively, you can also turn on the server module by using:
The server module iDRAC. For more
information, see the Log in to iDRAC section.
The enclosure Chassis Management
Controller (CMC), after the server module iDRAC is configured
on the CMC. For more information, see the CMC User’s Guide at Dell.com/idracmanuals.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\