- Notes, cautions, and warnings
- Introduction
- Advantages of using Lifecycle Controller
- Benefits of using iDRAC with Lifecycle Controller
- Key features
- New in this release
- Advantages of using Lifecycle Controller Remote Services
- Licensable features in Lifecycle Controller
- About iDRAC RESTful API with Redfish and Web Service APIs
- About Lifecycle Controller API
- About one-to-many management achieved
- Other information that you may need
- Accessing documents from the Dell EMC support site
- Contacting Dell
- Remote Services Features
- Deployment and configuration
- Monitor
- Maintain
- Job management
- Getting started with API collateral and links
- Integrating the Lifecycle Controller API
- Social media reference
- Terms and definitions
Damos-lhe as boas-vindas
Damos-lhe as boas-vindas à Dell
Minha conta
- Efetuar encomendas de forma rápida e fácil
- Ver todas as encomendas e controlar o seu estado de expedição
- Criar e aceder a uma lista dos seus produtos
- Gerencie seus sites, produtos e contatos de nível de produto da Dell EMC usando o Company Administration.
Dell Lifecycle Controller Remote Services v2.60.60.60 Quick Start Guide
Near Field Communication using the QuickSync feature
Using the QuickSync feature, you can:
View basic server information such as Service Tag, MAC address, NIC data, firmware versions, operating system, and so on.
View log and monitoring information of a server.
Configure network parameters of a server.
After viewing or editing the information, you can troubleshoot or configure using a mobile device. To use this feature, you must install the OpenManage Mobile (OMM) software application on your mobile device and enable the bezel on the server. The QuickSync feature enables your mobile device to act as a proximity reader which reads data on the server when held at a distance of less than 20 mm from the server front panel. You can perform most of the tasks that you complete by using an LCD panel. The system information is the basic hardware inventory information retrieved from NFC. The attributes allow you to set the access, check the presence of QuickSync feature, enable or disable the Inactivity Timer, set the inactivity timeout value.
NOTE: This feature
is supported only on Android mobile devices.
For more information on the QuickSync feature, see the System QuickSync profile document available at en.community.dell.com/techcenter/systems-management/w/wiki/1906.dcim-library-profile.aspx. Also, see iDRAC User’s Guide available at www.dell.com/esmmanuals.
Forneça as classificações (de 1 a 5 estrelas).
Forneça as classificações (de 1 a 5 estrelas).
Forneça as classificações (de 1 a 5 estrelas).
Selecione se o artigo foi útil ou não.
Os comentários não podem conter estes caracteres especiais: <>()\