CAUTION:Many repairs may only
be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation,
or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that are
shipped with your product.
NOTE:SD card slot 2 seen in this procedure is the vFlash SD card slot. You can install an SD card in SD card slot 2 to enable the
Internal SD Card Redundancy option in the
Integrated Devices screen of the System Setup.
Steps
Enter System Setup and ensure that the
Internal SD Card Port is enabled.
Note the
Internal SD Card Redundancy option that is enabled in the
Integrated Devices screen of the System Setup (Mirror or
Disabled).
NOTE:If you retain the original settings of the SD card in the System Setup, the replaced SD card is enabled when you reinstall the sled in the enclosure.
Remove the sled from the enclosure.
If the
Internal SD Card Redundancy option in the
Integrated Devices screen of the System Setup is set to
Mirror mode and SD card 1 has failed, replace the failed micro SD card with a new micro SD card.
If the
Internal SD Card Redundancy option in the
Integrated Devices screen of the System Setup is set to
Mirror mode and SD card 2 has failed, insert the new SD card into SD card slot 2.
If the
Internal SD Card Redundancy option in
Integrated Devices screen of the System Setup is set to
Disabled, replace the failed SD card with a new SD card.
Install the sled in the enclosure.
Enter System Setup and ensure that the
Internal SD Card Port option is enabled and
Internal SD Card Redundancy option is set to
Mirror mode.
Check if the SD card is functioning properly.
If the problem persists, see the Getting help section.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\