PowerEdge R350

This article provides information about the LIC008 error seen when importing the IDRAC License.

This article provides information about how to verify if a Network Interface Card (NIC) is compatible with a PowerEdge Server.

Dell Chicony power supply (X1HXF) reports an Under Voltage Fault event PSU0034.

This article provides information about CPU Machine Check errors and common causes and proper handling when errors are seen.

Unsure about the procedure to update a specific component's firmware in a PowerEdge system? Learn how to in this specific article.

Dell Samsung PM893 SSDs with Firmware HJ55 or Earlier Experience Premature SMART Failures

New deployments of OpenManage Enterprise 4.4.0 are experiencing service failures after configuring the time zone for GMT +02:00 Helsinki, Kyiv, Riga, Sofia, Tallinn, Vilnius. The issue is only seen on fresh deployment of OpenManage Enterprise (OME) 4.4.0 on Hyper-V. Deploying OpenManage Enterprise (OME) on other hypervisors is not impacted.

R7725, R6725, R7715, and R6715 the number of CPU Cores is not recognized correctly.

PowerEdge: Dell service support for end of industry production of 2.5" 15k RPM SAS hard drives

Dell Technologies advises against downgrading Hard Drive or SSD firmware, except in validated scenarios, due to unpredictable results and version reporting issues.

The "Predictive failure reported for disk x" error continues to be logged every 24 hours, even after the identified drive has been replaced. The issue only affects drives connected to PERC Controllers in RAID configuration.

During Windows Server 2025 installation by iDRAC virtual media, a disk with size 0 B is displayed on the drive selection page.

Leveraging the 'Reboot Required' filter and selecting all items in this filtered view results in the 'make compliant' job applying all non-compliant firmware components. An unexpected reboot of the target is seen as components that do require a restart are deployed to the target. The issue is only seen if selecting all objects and using the 'Reboot Required' filter. All other filters work as designed.

PowerEdge servers crash with PCIe fatal errors while updating Kioxia CM6 NVMe drive firmware.

CPUs can be perceived to be hot while server is idle.

Dust or chemical contamination at the endface of a fiber optic LC connector or transceiver module impedes signaling. Dell engineering teams have verified cases in which a fully functional port appears to be a bad port because dirty optical connectors manifest as a port failing loop testing with acceptable power measurement levels. Cable connectors should be cleaned and when stored must be protected from dust particle or chemical contamination.

During continuous reboot testing, the system may stop responding during the shutdown phase due to an internal error (CPU0000) on PowerEdge T150, R250, R350, T350 systems.

Seagate Summit SAS/SATA drives report medium errors or sense key 3/11 on PowerEdge and PowerVault systems due to a firmware issue causing weak writes to a drive sector.

The Dell SS540 SAS solid state drive is reported as not correctly functioning.

PowerEdge: Broadcom NXE devices with Driver 229.2.73 (SWB: Y7T4X) may report that the interfaces are missing in the operating system when secure boot is enabled.

In some instances, the firmware update job may fail to initiate when performing a firmware update through available iDRAC interfaces.

This article provides a step-by-step guide on how to remove and install a cooling fan on a Dell system. These instructions are applicable to both standard and high-performance fans. The guide covers the removal and installation of the cooling fan assembly.

In Windows Server 2025, when leveraging CPUs with more than 256 cores, the Broadcom BCM5720 fails to retrieve a DHCP address, leading to no network connectivity.

OpenManage Enterprise integration for VMware vCenter may fail to Unmanage hosts with error "UNMANAGE_REMOVE_MEL_FAILURE"

When a PS1010 or PS1030 NVMe SSD is installed, a PSOD may occur during production or gathering Operating System (OS) logs.

A stop during POST is possible after a customer changes Secure Boot Policy from either Standard or Custom to VMware Boot or Linux Boot.

This article describes the different type of controllers and the ways in which they should be reseated.

Warning messages regarding "icen_SetRxQueueFilter" and "Failed to add cloud filter" in ESXi 8 VMware VMkernel log.

The article describes how to troubleshoot network connectivity issues for network cards.

Seagate Skybolt and SkyboltServoBP drive fails with medium format corrupted errors.