How to replace the Memory Module on a Precision 7875 Tower

This 3D experience gives you the step by step process of replacing the Memory Module and a Precision 7875 Tower. The procedure will also include removing the Side Cover, Air Shroud and reinstalling them.

Removal

Side Cover

1. Identify the side cover highlighted in blue.
2. Unlock the side panel latch using a Phillips screwdriver.
3. Press to open the latch of the side cover. Pull the release latch to release the side cover from the chassis.
4. Open the side cover at an angle and lift the cover away from the chassis.

Air Shroud

1. Identify the air shroud highlighted in blue.
2. Hold the top air shroud at the grip points and pull it upwards out of the chassis.

Memory Module

1. Identify the memory module highlighted in blue.
2. Pull the securing clips from both side of the memory module until the memory module pops up.
3. Lift to remove the memory module from its slot.

Install

Memory Module

1. Identify the memory module location highlighted in blue.
2. Install the memory firmly into the slot on the system board.
3. Press the memory module down until it clicks into place.

Air Shroud

1. Identify the air shroud location highlighted in blue.
2. Install the air shroud and press the top air shroud down until the tabs click into place.

Side Cover

1. Identify the side cover location highlighted in blue.
2. Align the tabs with the slots and install the side cover on the chassis.
3. Using a Phillips screwdriver, turn the side panel latch to the locked position.