Removal
System Cover
Identify the system cover highlighted in blue.
Using a flat head or a Phillips #2 screwdriver, rotate the lock counter clockwise.
Lift the latch until the system cover slides back.
Hold the cover on both sides, and lift the cover away from the system.
Support bar
Identify the support bar highlighted in blue.
Pull the plunger and rotate to lock the plunger on the support bar.
If full-length risers are installed, then loosen the captive screws on the support bar that hold the risers.
Lift the support bar from the system.
Cooling fan cage assembly
Identify the cooling fan cage assembly highlighted in blue.
Rotate the cooling fan cage handle to unlock the cage assembly from the system.
Hold the handle, and lift the cooling fan cage assembly away from the system.
Air shroud top cover
Identify the air shroud top cover highlighted in blue.
Holding the edges of the air shroud top cover, lift the top cover out of the air shroud.
Rear mounting front PERC module
Identify the PERC module highlighted in blue.
Disconnect the cable from the connector on the PERC module.
Loosen the screws on the rear mounting front PERC module.
Slide the rear mounting front PERC module to disengage from the connector on the drive backplane.
Install
Rear mounting front PERC module
Identify the PERC module location highlighted in blue.
Align and slide the rear mounting front PERC module until the module is connected to the drive backplane.
Tighten the screws on the rear mounting front PERC module.
Connect the cable to the connector on the PERC module.
Air shroud top cover
Identify the air shroud top cover location highlighted in blue.
Align the top cover tabs with the slots on the air shroud and place the top cover until it is firmly seated.
Cooling fan cage assembly
Identify the cooling fan cage assembly location highlighted in blue.
Align and place the cooling fan cage assembly into the system until seated firmly.
Rotate the handle to lock the cooling fan cage assembly into the system.
Support bar
Identify the support bar location highlighted in blue.
Align and place the support bar tabs with the guide slots on the system.
Rotate the plunger to the lock support bar into the system.
If full-length risers are installed, then tighten the captive screws on the support bar that hold the risers.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system and slide the system cover.
Close the system cover release latch.
Using a flat head or Phillips #2 screwdriver, rotate the lock clockwise to the lock position.