How to replace the LOM riser card on a PowerEdge C6620

This 3D experience gives you the step by step process of replacing the LOM riser card and a PowerEdge C6620. The procedure will also include removing the Expansion card riser 1, Expansion card riser 2 and reinstalling them.

Removal

Expansion card riser 1

Identify the riser highlighted in blue.

Using a phillips #1 screwdriver, remove the screws that secure the expansion card riser 1.

Holding the handle, lift the expansion card riser from the riser connector on the system board.

Expansion card riser 2

Identify the riser highlighted in blue.

Using a phillips #1 screwdriver, remove the screws that secure the expansion card riser 2.

Holding the blue touch point and handle, lift the expansion card riser from the riser connector on the system board.

LOM riser card

Identify the LOM riser card highlighted in blue.

Using a phillips #2 screwdriver, remove the screws that secure the LOM card to the system board.

Lift the LOM card from the connector on the system board.

Install

LOM riser card

Identify the LOM riser card location highlighted in blue.

Align and install the LOM firmly until the LOM card is fully seated in the slot.

Using a phillips #2 screwdriver, install the screws that secure the LOM card to the system board.

Expansion card riser 2

Identify the riser location highlighted in blue.

Lower the riser card firmly until the riser card is fully seated in the slot.

Using a phillips #1 screwdriver, install the screws that secure the expansion card riser 2 on to the system board.

Expansion card riser 1

Identify the riser location highlighted in blue.

Lower the riser firmly until the riser card is fully seated in the slot.

Using a phillips #1 screwdriver, install the screws that secure the expansion card riser 1 on to the system board.