Removal
Front Bezel
Identify the front bezel highlighted in blue
Unlock the front bezel by using the key.
Press the release button, and pull the left end of the front bezel.
Unhook the right end, and remove the front bezel.
Drive Carrier
Select the drive carrier you want to replace.
Press the release button to open the release handle.
Holding the handle, slide the drive carrier out of the drive slot.
System Cover
Identify the system cover highlighted in blue.
Using a 1/4" Flathead or a Phillips #2 screwdriver, rotate the lock counter clockwise.
Lift the latch untill the system cover slides back.
Hold the cover on both sides, and lift the cover away from the system.
Front Top Cover
Identify the front top cover highlighted in blue
Slide the front top cover in the direction of the arrows marked on the front top cover and Lift the front top cover from the system.
Hard Drive Backplane
Identify the hard drive backplane highlighted in blue
Disconnect the drive backplane cables from the connector on the backplane.
Press the blue release tabs to disengage the drive backplane from the hooks on the system.
Lift and pull the drive backplane out of the system.
Install
Hard Drive Backplane
Identify the hard drive backplane location highlighted in blue
Use the guides on the system as guides to align the slots on the backplane.
Insert the backplane into the guides and lower the backplane until the blue release tabs clicks into place
Connect the all data, signal, and power cable(s) to the backplane.
Front Top Cover
Identify the front top cover location highlighted in blue
Slide the front top cover to the front of the system until the front top cover fits into place.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system.
Push the system cover latch down.
Using a 1/4" Flathead or a Phillips #2 screwdriver, rotate the lock clockwise.
Drive Carrier
Confirm the highlighted drive is the correct location to install or change selection.
Press the release button on the front of the drive carrier to open the release handle.
Insert the drive carrier into the slot and slide until it connects with the backplane.
Close the drive carrier release handle to lock the drive in place.
Front Bezel
Identify the front bezel location highlighted in blue
Hook the right end of the front bezel onto the system.
Fit the free end of the front bezel onto the system.
Lock the front bezel by using the key.