Removal
BOSS-N1 Card Carrier
Identify the BOSS-N1 card carrier highlighted in blue.
Pull and lift the BOSS-N1 card carrier retention latch lock to open.
Slide the BOSS-N1 card carrier out.
System Cover
Identify the system cover highlighted in blue.
Using a 1/4" Flathead or a Phillips #2 screwdriver, rotate the lock counter clockwise.
Lift the latch untill the system cover slides back.
Hold the cover on both sides, and lift the cover away from the system.
Airshroud
BOSS-N1 Module
Identify the optional BOSS-N1 module highlighted in blue.
Slide the BOSS-N1 shroud towards to front of the system and lift the shroud from the system.
Remove the BOSS-N1 power and signal cable from the BOSS-N1 module.
Remove the screw that secures the BOSS-N1 module.
Slide the BOSS-N1 module toward the front of the chassis and lift the module.
Install
BOSS-N1 Module
Identify the optional BOSS-N1 module location highlighted in blue.
Insert the BOSS-N1 module and push the module horizontally toward the rear of the system until firmly seated.
Install the screw to secure the BOSS-N1 module.
Connect the BOSS-N1 power and signal cables to the connectors on the BOSS-N1 module.
Align the BOSS-N1 shroud with the BOSS-N1 module bay, lower the shroud into the system and slide to the back of the system until it is firmly seated.
Airshroud
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system.
Push the system cover latch down.
Using a 1/4" Flathead or a Phillips #2 screwdriver, rotate the lock clockwise.
BOSS-N1 Card Carrier
Identify the BOSS-N1 card carrier location highlighted in blue.
Slide the BOSS-N1 card carrier into the BOSS-N1 module slot.
Close the BOSS-N1 card carrier release latch to lock the carrier in place.