Removal
System Cover
Identify the system cover highlighted in blue.
Using a 1/4" Flathead or a Phillips #2 screwdriver, rotate the lock counter clockwise.
Lift the latch untill the system cover slides back.
Hold the cover on both sides, and lift the cover away from the system.
Cooling Shroud
Identify the cooling fans highlighted in blue
Hold the orange release tab and lift the cooling fan to disconnect the fan from the connector on the system board.
System Memory
Select the system memory you want to replace. System can have up to 32 dimms installed.
To release the memory module from the socket, simultaneously press the ejectors on both ends of the socket.
Holding the memory by the edges, lift to remove.
Install
System Memory
Confirm the highlighted memory DIMM is the correct location to install or change selection.
Align the edge connector of memory module with the alignment key of the memory module socket, and insert into the socket.
Press the memory module until the socket levers firmly click into place.
Cooling Shroud
Identify the cooling fans location highlighted in blue
Align and lower the cooling fan into the cooling fan assembly until the fan clicks into place.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system.
Push the system cover latch down.
Using a 1/4" Flathead or a Phillips #2 screwdriver, rotate the lock clockwise.