Removal
System Cover
Identify the system cover highlighted in blue.
Using a 1/4" Flathead or a Phillips #2 screwdriver, rotate the lock counter clockwise.
Lift the latch untill the system cover slides back.
Hold the cover on both sides, and lift the cover away from the system.
Air Shroud
Identify the air shroud highlighted in blue
Press the release tab on both side of the air shroud.
Hold the edges of the air shroud, and lift the air shroud out of the system.
Riser 4 Assembly
Identify the system cover highlighted in blue.
Using a 1/4" Flathead or a Phillips #2 screwdriver, rotate the lock counter clockwise.
Lift the latch untill the system cover slides back.
Hold the cover on both sides, and lift the cover away from the system.
Intrusion switch
Identify the Intrusion Switch Module highlighted in blue
Disconnect the intrusion switch cable from the connector on the rear I/O board.
Loosen the screw on the intrusion switch module.
Lift the intrusion switch module out of the slot on the system.
Install
Intrusion switch
Identify the Intrusion Switch Module location highlighted in blue
Align and slide the intrusion switch module into the slot in the system until firmly seated.
Tighten the screw on the intrusion switch module.
Connect the intrusion switch cable to the connector on the rear I/O board.
Riser 4 Assembly
Identify the front bezel location highlighted in blue
Hook the right end of the front bezel onto the system.
Fit the free end of the front bezel onto the system.
Lock the front bezel by using the key.
Air Shroud
Identify the air shroud location highlighted in blue
Align the tabs on the air shroud with the slots on the system.
Lower the air shroud into the system until it clicks into place.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system.
Push the system cover latch down.
Using a 1/4" Flathead or a Phillips #2 screwdriver, rotate the lock clockwise.