Removal
System Cover
Identify the system cover highlighted in blue.
Using a flat head or a Phillips screwdriver, rotate the lock counter clockwise.
Lift the latch until the system cover slides back.
Hold the cover on both sides, and lift the cover away from the system.
Front Bezel
Identify the front bezel highlighted in blue
Unlock the front bezel by using the key.
Press the release button and disengage the left end of the bezel.
Unhook the right end, and remove the front bezel.
Backplane
Identify the hard drive backplane highlighted in blue
Press the release button to open the release handle.
Holding the handle, slide the drive carrier out of the drive slot.
Disconnect the cables from the backplane.
Pull the plunger to disengage the drive backplane from the hooks on the system.
Lift and pull the drive backplane out of the system.
Install
Backplane
Identify the hard drive backplane location highlighted in blue
Align the slots on the drive backplane with the guides on the system.
Insert the backplane into the guides and lower the backplane until the blue release tabs clicks into place.
Connect the cables to the backplane.
Insert the drive carrier into the slot and slide until it connects with the backplane.
Close the drive carrier release handle to lock the drive in place.
Front Bezel
Identify the front bezel location highlighted in blue
Align and insert the tabs on the bezel into the slots on the system.
Press the bezel until the release button clicks in place.
Lock the front bezel by using the key.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system and slide the system cover.
Close the system cover release latch.
Using a flat head or Phillips screwdriver, rotate the lock clockwise to the lock position.