Removal
System Cover
Identify the system cover highlighted in blue.
Using a 1/4" Flathead or a Phillips #2 screwdriver, rotate the lock counter clockwise.
Lift the latch till the system cover slides back.
Hold the cover on both sides, and lift the cover away from the system.
Air Shroud
Identify the air shroud highlighted in blue
Holding the blue touch points, apply firm pressure to remove the air shroud.
Riser 1A Assembly
Identify the riser 1A highlighted in blue
Press the release latches and lift the riser from the system board
System Battery (Coin Cell)
Identify the system battery highlighted in blue
Use a plastic scribe to pry out the system battery.
Lift the battery out of the socket.
Install
System Battery (Coin Cell)
Identify the system battery location highlighted in blue
Install the battery with the "+" facing up and slide it under the securing tabs.
Press the battery into the connector until it snaps into place.
Riser 1A Assembly
Identify the riser 1A location highlighted in blue
Holding the touch points, align the expansion card riser with the connector and the riser guide pin on the system board.
Lower the expansion card riser into place until the expansion card riser connector is fully seated in the connector.
Air Shroud
Identify the air shroud location highlighted in blue
Align the tabs on the air shroud with the slots on the system.
Lower the air shroud into the system until it clicks into place.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system.
Push the system cover latch down.
Using a 1/4" Flathead or a Phillips #2 screwdriver, rotate the lock clockwise.