Removal
System Cover
Identify the system cover highlighted in blue.
Using a 1/4" Flathead or a Phillips #2 screwdriver, rotate the lock counter clockwise.
Lift the latch till the system cover slides back.
Hold the cover on both sides, and lift the cover away from the system.
Air Shroud
Identify the air shroud highlighted in blue
Holding the blue touch points, apply firm pressure to remove the air shroud.
Integrated storage controller card
Identify the integrated storage controller card highlighted in blue
Loosen the screws that secure the cable to the card connector on the system board
Route the integrated storage controller card cable along the wall of the system.
Lift the cable away from the integrated storage controller.
Lift one end of the card and angle it to disengage the card from the card holder on the system board.
Lift the card out of the system.
Install
Integrated storage controller card
Identify the Integrated Storage Controller location on the system board.
Angle the integrated storage controller card and align the end of the card with the controller card connector on the system
board.
Lower the connector side of the integrated storage controller card into the integrated storage controller card connector on
the system board.
Route the integrated storage controller card cable along the wall of the system.
Align the screws on the integrated storage controller card cable with the screw holes on the connector.
Tighten the screws to secure the integrated storage controller card cable to the system board.
Air Shroud
Identify the air shroud location highlighted in blue
Align the tabs on the air shroud with the slots on the system.
Lower the air shroud into the system until it clicks into place.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system.
Push the system cover latch down.
Using a 1/4" Flathead or a Phillips #2 screwdriver, rotate the lock clockwise.