Removal
System Cover
Identify the system cover highlighted in blue.
Using a flat head or a Phillips screwdriver, rotate the lock counter clockwise.
Lift the latch till the system cover slides back.
Hold the cover on both sides, and lift the cover away from the system.
Riser 01 assembly
Identify the Riser 01 highlighted in blue
Loosen the captive screws on the riser.
Press the blue button on the riser, and holding the touch points lift the expansion card riser 01 from the riser connector on the system board.
Internal Dual SD Module (IDSDM)
Identify the internal dual SD module (IDSDM) highlighted in blue
Pull up on the blue pull tab and lift the IDSDM out of the system
Internal SD Card
Position the part as shown.
Identify the internal SD card highlighted in blue
Locate the SD card slot on the internal dual SD module (IDSDM)
Press the card down to release it from the slot
Install
Internal SD Card
Position the part as shown.
Identify the internal SD card location highlighted in blue
Orient the SD card appropriately and insert into the slot.
Press the card into the card slot to lock it into place.
Internal Dual SD Module (IDSDM)
Identify the internal dual SD module (IDSDM) location highlighted in blue
Align the IDSDM connector with the connector on the system board
Press the IDSDM into the connector
Riser 01 assembly
Identify the Riser 01 location highlighted in blue
Holding the edges or the touch points, align the holes on the expansion card riser 01 with the guides on the system board.
Lower the expansion card riser 01 into place and press the touch points until the expansion card riser connector is fully seated on the system board connector.
Tighten the captive screws on the riser.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system.
Push the system cover latch down.
Using a flat head or Phillips screwdriver, rotate the lock clockwise.