Removal
System Cover
Identify the system cover highlighted in blue.
Using a flat head or a Phillips screwdriver, rotate the lock counter clockwise.
Lift the latch till the system cover slides back.
Hold the cover on both sides, and lift the cover away from the system.
Air shroud
Identify the air shroud highlighted in blue
Holding the touch points, lift the cooling shroud away from the system.
Internal Dual SD Module (IDSDM)
Identify the internal dual SD module (IDSDM) highlighted in blue
Pull up on the blue pull tab and lift the IDSDM out of the system
Internal SD Card
Position the internal dual SD module (IDSDM) over as shown.
Identify the internal SD card highlighted in blue
Locate the SD card slot on the internal dual SD module (IDSDM)
Press the card down to release it from the slot
Install
Internal SD Card
Position the internal dual SD module (IDSDM) over as shown.
Identify the internal SD card location highlighted in blue
Orient the SD card appropriately and insert into the slot.
Press the card into the card slot to lock it into place.
Internal Dual SD Module (IDSDM)
Identify the internal dual SD module (IDSDM) location highlighted in blue
Align the IDSDM connector with the connector on the system board
Press the IDSDM into the connector
Air shroud
Identify the cooling shroud location highlighted in blue
Align the slot on the air shroud with the standoff on the chassis.
Lower the air shroud into the system until it is firmly seated.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system.
Push the system cover latch down.
Using a flat head or Phillips screwdriver, rotate the lock clockwise.