Removal
Side Cover
Identify the side cover highlighted in blue.
Slide the release latch to release the side cover from the computer.
Slide the side cover back and lift it off the chassis.
Front bezel
Identify the front bezel highlighted in blue.
Gently pry and release the front bezel tabs sequentially from the top.
Rotate the front bezel outward from the chassis and remove the front bezel.
Powered graphics card
Identify the powered graphics card highlighted in blue.
Disconnect the power cables from the connector on the graphics card.
Remove the power cable from the routing guides on the cable holder.
Press the clips on both sides of the cable holder and slide it out of the computer.
Push the tab on the graphics card support bracket and rotate it to move it away from the chassis.
Press and hold the tab on the graphics card slot, then lift the graphics card out of the slot.
Install
Powered graphics card
Identify the powered graphics card location highlighted in blue
Using the alignment post, connect the graphics card in the connector and press down firmly.
Close the PCIe latch to secure the graphics card in the slot.
Align and place the cable holder on the computer chassis until it clicks to place.
Route the power cable through the retention tab on the cable holder.
Connect the power cables from the connector on the graphics card.
Front bezel
Identify the front bezel location highlighted in blue.
Align the front cover tabs with the slots on the chassis.
Rotate the front cover towards the chassis and snap it into place.
Side Cover
Identify the side cover location highlighted in blue.
Align the tabs on the side cover with the slots on the chassis.
Slide the side cover forward until you hear the latch click.