Removal
System Cover
Identify the system cover highlighted in blue.
Using a 1/4 inch flat head or a phillips #2 screwdriver, rotate the lock counterclockwise to the unlock position.
Lift the release latch until the system cover slides back.
Lift the system cover from the system.
Air Shroud
Identify the air shroud highlighted in blue.
Hold the edges of the air shroud, and lift the air shroud out of the system.
Riser - 2b
Identify the riser highlighted in blue.
Unlock the riser latch, lift the riser to disconnect it from the connector, and remove it from the guide pin and cage.
Riser - 2b Expansion Card
Position the Riser as shown.
Identify the rear expansion card highlighted in blue.
Pull and lift the expansion card retention latches on both ends of the riser.
Hold the rear expansion card by its edges and pull it to disengage it from the riser connector.
Install
Riser - 2b Expansion Card
Identify the rear expansion card location highlighted in blue.
Align the rear expansion card with the riser, then insert it firmly until fully seated.
Close the expansion card retention latches on both ends of the riser.
Riser - 2b
Identify the riser location highlighted in blue.
Align the riser with the connector and guide pin, lower it, press to seat it fully, then lock it with the riser latch.
Air Shroud
Identify the air shroud location highlighted in blue.
Holding the edges of the air shroud, align the tabs on the air shroud with the standoff on the chassis.
Lower the air shroud into the system until it is firmly seated.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system, then slide the cover into place.
Close the system cover release latch.
Using a 1/4 inch flat head or phillips #2 screwdriver, rotate the lock clockwise to the lock position.