Removal
System Cover
Identify the system cover highlighted in blue.
Using a 1/4 inch flat head or a phillips #2 screwdriver rotate the lock counterclockwise to the unlock position.
Lift the release latch until the system cover slides back.
Lift the cover from the system.
Air Shroud
Identify the air shroud highlighted in blue.
Hold the edges of the air shroud, and lift the air shroud out of the system.
Drive backplane cover
Identify the drive backplane cover highlighted in blue.
Slide the backplane cover in the direction of the arrows marked on the drive backplane cover.
Lift the backplane cover from the system.
Cooling Fan cage assembly
Identify the cooling fan cage assembly highlighted in blue.
Lift the blue release levers to unlock the cooling fan cage assembly from the system.
Hold the release levers, and lift the cooling fan cage assembly away from the system.
Side wall bracket - Right
Identify the side wall bracket highlighted in blue.
Press the tab to release the side wall bracket cover.
Unroute the cables to release them from the side wall bracket.
Press the center tab to release the bracket from the chassis, and lift it away from the system.
Control panel - Right
Identify the control panel highlighted in blue.
Disconnect the right control panel cable and the VGA cable from the connectors on the system board.
Using the phillips #1 screwdriver, remove the screws that secure the cable cover to the system.
Remove the cable cover away from the system.
Unroute the right control panel cable from the side wall of the system.
Using the phillips #1 screwdriver, remove the screws that secure the right control panel to the system.
Holding the right control panel and VGA cable assembly, slide the right control panel out of the system.
Install
Control panel - Right
Identify the control panel location highlighted in blue.
Align and slide the right control panel into the slot on the system.
Route the right control panel cable through the side wall of the system.
Using the phillips #1 screwdriver, install the screws that secure the left control panel to the system.
Align and slide the right control panel cable cover in the slot on the system.
Using the phillips #1 screwdriver, install the screws that secure the cable cover to the system.
Connect the right control panel cable and VGA cable to the connectors on the system board.
Side wall bracket - Right
Identify the side wall bracket location highlighted in blue.
Align the side wall bracket with the tabs on the chassis.
Press the side wall bracket with your thumbs untill the bracket firmly clicks into place.
Route the cables through the side wall bracket.
Close the side wall bracket cover with your thumbs untill the cover firmly clicks into into place.
Cooling Fan cage assembly
Identify the cooling fan cage assembly location highlighted in blue.
Holding the blue release lever of the cooling fan cage, align the guide rails with the guides on the system.
Lower the cooling fan cage assembly into the system until seated firmly.
Lower the blue release lever and press to lock the cooling fan cage assembly into the system.
Drive backplane cover
Identify the drive backplane cover location highlighted in blue.
Align the drive backplane cover with the guide slots on the system.
Slide the drive backplane cover to the front of the system until the drive backplane cover fits into place.
Air Shroud
Identify the air shroud location highlighted in blue.
Align the slot on the air shroud with the standoff on the system.
Lower the air shroud into the system until it is firmly seated.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system and slide the system cover.
Close the system cover release latch.
Using a 1/4 inch flat head or phillips #2 screwdriver, rotate the lock clockwise to the lock position.