Removal
Side Cover
Identify the side cover highlighted in blue.
Loosen the captive screw that secures the side cover to the chassis.
Pull the release latch to release the cover from the chassis.
Lift the side cover from the chassis.
Front Bezel
Identify the front bezel highlighted in blue.
Pry the retention tabs to release the front bezel from the chassis.
Gently rotate to release the other tabs from the slots in the chassis and remove the front bezel from the computer.
Air shroud
Identify the air shroud highlighted in blue.
Hold the air shroud at the gripping points and Pull the air shroud upwards and out of the computer.
Internal Speaker
Identify the internal speaker highlighted in blue.
Disconnect the internal speaker cable from the connector on the system board.
Unroute the internal speaker cable through the recess on the chassis.
Slide and remove the internal speaker from the chassis.
Install
Internal Speaker
Identify the internal speaker location highlighted in blue.
Insert the internal speaker into its slot on the system.
Route the internal speaker cable through the recess on the front of the chassis.
Connect the internal speaker cable to the connector on the system board.
Air shroud
Identify the air shroud location highlighted in blue.
Align the air shroud over the heat sink and system board holding and place it in the slot.
Press the air shroud down until the tabs secure into place.
Front Bezel
Identify the front bezel location highlighted in blue.
Align the front bezel tabs with the slots on the chassis.
Rotate the front bezel towards the chassis and snap into place.
Side Cover
Identify the side cover location highlighted in blue.
Align with the tabs and install the side cover on to the chassis.
Tighten the captive screw to secure the side cover to the chassis.