Removal
Side Cover
Identify the side cover highlighted in blue.
Loosen the captive screw that secures the side cover to the chassis.
Pull the release latch to release the cover from the chassis.
Lift the side cover from the chassis.
GPU End Holder
Identify the GPU end holder highlighted in blue.
Slide the latch to unlock position on the GPU end holder.
Press the retention tabs on both sides and lift the GPU end holder remove from the computer.
Air shroud
Identify the air shroud highlighted in blue.
Hold the air shroud at the gripping points and Pull the air shroud upwards and out of the computer.
Powered GPU
Identify the powered GPU highlighted in blue.
Slide the release latch on the graphics card holder and lift it out of the computer.
Disconnect the power cables from the connector on the powered GPU and the power supply unit.
Lift the pull tab to open the PCIe door.
Push and hold the securing tab on the graphics card slot and lift the powered GPU away from the graphics card slot.
Install
Powered GPU
Identify the powered GPU location highlighted in blue.
Align the powered GPU with the PCI Express card connector on the system board.
Using the alignment post, connect the powered GPU to the connector and press down firmly.
Lift the pull tab to close the PCIe door.
Connect the power cables to the connector on the powered GPU and the power supply unit.
Slide the release latch on the graphics card holder and insert it into the slot until it secures to its place.
Air shroud
Identify the air shroud location highlighted in blue.
Align the air shroud over the heat sink and system board holding and place it in the slot.
Press the air shroud down until the tabs secure into place.
GPU End Holder
Identify the GPU end holder location highlighted in blue.
Position the GPU end holder to align it with the slots on the computer.
Press the GPU end holder down until it secures into place.
Slide the latch to lock position on the GPU end holder.
Side Cover
Identify the side cover location highlighted in blue.
Align with the tabs and install the side cover on to the chassis.
Tighten the captive screw to secure the side cover to the chassis.