Removal
System Cover
Identify the system cover highlighted in blue.
Using a flat head or a Phillips screwdriver, rotate the lock counter clockwise.
Lift the latch till the system cover slides back.
Hold the cover on both sides, and lift the cover away from the system.
Airshroud
Low profile right riser
Identify the low profile right riser highlighted in blue
Hold the touch points and lift the expansion card riser from the riser connector on the system board.
Position the riser so that the expansion card will be visible to remove.
Open the expansion card latch
Remove the expansion card from the riser and the remaining part is low profile right riser.
Low profile left riser
Identify the low profile left riser highlighted in blue
Hold the touch points and lift the expansion card riser from the riser connector on the system board.
Position the riser so that the expansion card will be visible to remove.
Open the expansion card latch
Remove the expansion card from the riser and the remaining part is low profile left riser.
System Battery (Coin Cell)
Identify the system battery highlighted in blue
Use a plastic scribe to pry out the system battery.
Lift the battery out of the socket.
Install
System Battery (Coin Cell)
Identify the system battery location highlighted in blue
Install the battery with the "+" facing up and slide it under the securing tabs.
Press the battery into the connector until it snaps into place.
Low profile left riser
Identify the low profile left riser location highlighted in blue
Position the riser to install the expansion card.
Insert the expansion card into the expansion card connector until the card is fully seated.
Close the expansion card latch
Lower the low profile left riser until the riser connector is fully seated in the connector of the system board.
Low profile right riser
Identify the low profile right riser location highlighted in blue
Position the riser to install the expansion card.
Insert the expansion card into the expansion card connector until the card is fully seated.
Close the expansion card latch
Lower the low profile right riser until the riser connector is fully seated in the connector of the system board.
Airshroud
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system.
Push the system cover latch down.
Using a flat head or Phillips screwdriver, rotate the lock clockwise.