How to replace the Internal Dual SD Module on a Poweredge R640

This 3D experience gives you the step by step process of replacing the Internal Dual SD Module and a Poweredge R640. The procedure will also include removing the System Cover, Air Shroud, Internal Dual SD Module (IDSDM) and reinstalling them.

Removal

System Cover

Identify the system cover highlighted in blue.

Using a 1/4" Flathead or a Phillips #2 screwdriver, rotate the lock counter clockwise.

Lift the latch till the system cover slides back.

Hold the cover on both sides, and lift the cover away from the system.

Air Shroud

Identify the air shroud highlighted in blue

Holding the blue touch points, apply firm pressure to remove the air shroud.

Internal Dual SD Module (IDSDM)

Identify the internal dual SD module (IDSDM) highlighted in blue

Pull up on the blue pull tab and lift the IDSDM out of the system

Install

Internal Dual SD Module (IDSDM)

Identify the internal dual SD module (IDSDM) location highlighted in blue

Align the IDSDM connector with the connector on the system board

Press the IDSDM into the connector

Air Shroud

Identify the air shroud location highlighted in blue

Align the tabs on the air shroud with the slots on the system.

Lower the air shroud into the system until it clicks into place.

System Cover

Identify the system cover location highlighted in blue.

Align the tabs on the system cover with the guide slots on the system.

Push the system cover latch down.

Using a 1/4" Flathead or a Phillips #2 screwdriver, rotate the lock clockwise.