Removal
Side Cover
Identify the side cover highlighted in blue.
Loosen the captive screw that secures the side cover to the chassis.
Pull the release latch to release the cover from the chassis.
Lift the side cover from the chassis.
Air shroud
Identify the air shroud highlighted in blue.
Hold the air shroud at the gripping points and Pull the air shroud upwards and out of the computer.
Intrusion Switch
Identify the intrusion switch highlighted in blue.
Disconnect the intruder cable from the connector on the system board.
Unroute the cable from the routing guide on the chassis.
Slide and remove the intrusion switch from the chassis.
Install
Intrusion Switch
Identify the intrusion switch location highlighted in blue.
Insert the intrusion switch into its slot and slide the switch to secure it into the slot.
Route the intruder cable through the routing guide on the chassis.
Connect the intruder cable to the connector on the system board.
Air shroud
Identify the air shroud location highlighted in blue.
Align the air shroud over the heat sink and system board holding and place it in the slot.
Press the air shroud down until the tabs secure into place.
Side Cover
Identify the side cover location highlighted in blue.
Align with the tabs and install the side cover on to the chassis.
Tighten the captive screw to secure the side cover to the chassis.