Removal
Side Cover
Identify the side cover highlighted in blue.
Loosen the captive screw that secures the side cover to the chassis.
Pull the release latch to release the cover from the chassis.
Lift the side cover from the chassis.
Front Bezel
Identify the front bezel highlighted in blue.
Pry the retention tabs to release the front bezel from the chassis.
Gently rotate to release the other tabs from the slots in the chassis and remove the front bezel from the computer.
Air shroud
Identify the air shroud highlighted in blue.
Hold the air shroud at the gripping points and Pull the air shroud upwards and out of the computer.
Power Button
Identify the power button highlighted in blue.
Disconnect the power button cable from the connector on the system board.
Press the release tabs on the power button head and push the power button head outside the chassis.
Slide the power button cable out from the front side of the chassis and remove it from the system.
Install
Power Button
Identify the power button location highlighted in blue.
Insert the power button cable through the slot on the chassis from the front side of the computer.
Align and place the power button head into the slot on the chassis until it clicks into the place.
Connect the power button cable to the connector on the system board.
Air shroud
Identify the air shroud location highlighted in blue.
Align the air shroud over the heat sink and system board holding and place it in the slot.
Press the air shroud down until the tabs secure into place.
Front Bezel
Identify the front bezel location highlighted in blue.
Align the front bezel tabs with the slots on the chassis.
Rotate the front bezel towards the chassis and snap into place.
Side Cover
Identify the side cover location highlighted in blue.
Align with the tabs and install the side cover on to the chassis.
Tighten the captive screw to secure the side cover to the chassis.