Removal
System Cover
Identify the system cover highlighted in blue.
Using a flat head or a Phillips screwdriver, rotate the lock counter clockwise.
Lift the latch till the system cover slides back.
Hold the cover on both sides, and lift the cover away from the system.
Butterfly riser
Identify the butterfly riser assembly highlighted in blue
Loosen the captive screw that secures the riser to the system
Hold the touch points, and lift the expansion card riser, from the riser connector, on the system board.
Air shroud
Identify the air shroud highlighted in blue
Holding the touch points, lift the cooling shroud away from the system.
Front Bezel
Identify the front bezel highlighted in blue
Unlock the front bezel by using the key.
Press the release button, and pull the left end of the front bezel.
Unhook the right end, and remove the front bezel.
Backplane
Identify the hard drive backplane highlighted in blue
Using the blue touchpoints, slide the backplane cover back and lift to remove.
Press the release button to open the drive carrier release handle on all hard drives installed.
Holding the handle, pull the drive out partially to disengage from the drive plane.
Press the blue release tabs and lift the backplane to disengage the backplane from the hooks on the system.
Install
Backplane
Identify the hard drive backplane location highlighted in blue
Use the hooks on the system as guides to align the slots on the backplane with the guides on the system.
Lower the drive backplane until the blue release tabs snap into place.
Slide the drives into place and close to latch to secure.
Insert the drive carrier into the slot and slide until it connects with the backplane.
Close the drive carrier release handle to lock the drive in place.
Front Bezel
Identify the front bezel location highlighted in blue
Hook the right end of the front bezel onto the system.
Fit the free end of the front bezel onto the system.
Lock the front bezel by using the key.
Air shroud
Identify the cooling shroud location highlighted in blue
Align the tabs on the air shroud with the slots on the system.
Lower the air shroud into the system until it is firmly seated.
StepInfoTxt
Butterfly riser
Identify the butterfly riser assembly location highlighted in blue
Lower the expansion card riser into place until the expansion card riser connector is fully seated in the connector.
Tighten the captive screw that secures the riser to the system
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system.
Push the system cover latch down.
Using a flat head or Phillips screwdriver, rotate the lock clockwise.
StepInfoTxt