Removal
System Cover
Identify the system cover highlighted in blue.
Using a 1/4 inch flat head or a phillips #2 screwdriver, rotate the lock counterclockwise to the unlock position.
Lift the release latch until the system cover slides back.
Lift the system cover from the system.
Air Shroud
Identify the air shroud highlighted in blue.
Hold the edges of the air shroud, and lift the air shroud out of the system.
Processor and Heatsink Module(PHM)
Identify the processor and heat sink module highlighted in blue
Using a Torx #T30 screwdriver, In a diagonal sequence, loosen all 4 nuts 3 turns. Then repeat the sequence to completely loosen the nuts.
Set all the anti tilt wires to unlocked position (inward position).
Lift the PHM from the system and set the PHM aside with the processor side facing up.
Install
Processor and Heatsink Module(PHM)
Identify the processor and heat sink module location highlighted in blue
Set the anti tilt wires to the unlocked position on the heat sink (inward position).
Align the pin 1 indicator of the heat sink with the system board and then place the processor heat sink module (PHM) on the processor socket.
Set the anti tilt wires to the locked position (outward position),
Using a Torx #T30 screwdriver, In a diagonal sequence, tighten all four nuts 3 turns. Then repeat the sequence to completely tighten the nuts.
Air Shroud
Identify the air shroud location highlighted in blue.
Holding the edges of the air shroud, align the tabs on the air shroud with the standoff on the chassis.
Lower the air shroud into the system until it is firmly seated.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system, then slide the cover into place.
Close the system cover release latch.
Using a 1/4 inch flat head or phillips #2 screwdriver, rotate the lock clockwise to the lock position.