Removal
Front Bezel
Drive carrier
System Cover
Identify the system cover highlighted in blue.
Using a 1/4 inch flat head or a phillips #2 screwdriver rotate the lock counterclockwise to the unlock position.
Lift the release latch until the system cover slides back.
Lift the cover from the system.
Air Shroud
Identify the air shroud highlighted in blue.
Hold the edges of the air shroud, and lift the air shroud out of the system.
Drive backplane cover
Identify the drive backplane cover highlighted in blue.
Slide the backplane cover in the direction of the arrows marked on the drive backplane cover.
Lift the backplane cover from the system.
Cooling Fan cage assembly
Identify the cooling fan cage assembly highlighted in blue.
Lift the blue release levers to unlock the cooling fan cage assembly from the system.
Hold the release levers, and lift the cooling fan cage assembly away from the system.
Rear mounting front PERC module
Identify the rear mounting front PERC module highlighted in blue.
Disconnect the cable from the rear PERC module.
Using a phillips #2 screwdriver, loosen the captive screws on the rear mounting front PERC module.
Slide the rear mounting front PERC module to disengage from the connector on the drive backplane.
Install
Rear mounting front PERC module
Identify the rear mounting front PERC module location highlighted in blue.
Align the connectors and guide slots on the front PERC module with the connectors and guide pins on the drive backplane.
Slide the rear mounting front PERC module until the module is connected to the drive backplane.
Using a phillips #2 screwdriver, tighten the captive screws on the rear mounting front PERC module.
Connect the cable to the rear PERC module.
Cooling Fan cage assembly
Identify the cooling fan cage assembly location highlighted in blue.
Holding the blue release lever of the cooling fan cage, align the guide rails with the guides on the system.
Lower the cooling fan cage assembly into the system until seated firmly.
Lower the blue release lever and press to lock the cooling fan cage assembly into the system.
Drive backplane cover
Identify the drive backplane cover location highlighted in blue.
Align the drive backplane cover with the guide slots on the system.
Slide the drive backplane cover to the front of the system until the drive backplane cover fits into place.
Air Shroud
Identify the air shroud location highlighted in blue.
Align the slot on the air shroud with the standoff on the system.
Lower the air shroud into the system until it is firmly seated.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system and slide the system cover.
Close the system cover release latch.
Using a 1/4 inch flat head or phillips #2 screwdriver, rotate the lock clockwise to the lock position.
Drive carrier
Front Bezel