How to replace the Retractable Camera Assembly on a OptiPlex AIOPlus7420

This 3D experience gives you the step by step process of replacing the Retractable Camera Assembly and a OptiPlex AIOPlus7420. The procedure will also include removing the Stand, Back Cover, System Board Shield and reinstalling them.

Removal

Stand

Identify the stand highlighted in blue.

Press and hold down on the tab that secures the stand to the display assembly base.

Slide and lift the stand off the display assembly base.

Back Cover

Identify the back cover highlighted in blue.

Press down on the tab and slide the back cover to release.

Lift the back cover off the display assembly base.

System Board Shield

Identify the system board shield highlighted in blue.

Remove the screws that secure the system board shield to the display assembly base.

Lift the system board shield off the display assembly base.

Retractable Camera Assembly

Identify the retractable camera assembly highlighted in blue.

Remove the screws that secure the camera assembly bracket to the display assembly base.

Lift the camera assembly bracket off the display assembly base.

Using the pull tab, disconnect the camera cable from the system board.

Remove the screws that secure the retractable camera assembly to the display assembly base.

Slide the camera assembly under the heat sink and lift to remove.

Install

Retractable Camera Assembly

Identify the retractable camera assembly location highlighted in blue.

Slide the retractable camera assembly under the heat sink on the display assembly base.

Install the screws that secure the retractable camera assembly to the display assembly base.

Connect the camera cable to the system board.

Place the camera assembly bracket over retractable camera assembly.

Install the screws that secure the camera assembly bracket to the display assembly base.

System Board Shield

Identify the system board shield location highlighted in blue.

Place the system board shield on the display assembly base and align with screw holes.

Install the screws that secure the system board shield to the display assembly base.

Back Cover

Identify the back cover location highlighted in blue.

Align the back cover to the display assembly base.

Place and slide the back cover into place on the display assembly base.

Stand

Identify the stand location highlighted in blue.

At an angle, align the tabs on the stand with the slots on the display assembly base.

Slide the stand into place into the slot on the display assembly base.