Removal
Base Cover
Identify the base cover highlighted in blue.
Loosen the captive screws that secure the base cover.
Pry the base cover near the hinges. Pry from recess points near the hinges.
Loosen the base covery by working on the left, right and, bottom sides to open the base cover.
Lift to remove the base cover.
Memory Modules
Identify the memory module highlighted in blue.
Using your fingertips, carefully spread apart the securing clips until the memory module pops up.
Hold the edges and carefully lift the memory module up from connector on the system board.
Install
Memory Modules
Identify the memory module location highlighted in blue.
Align the notch on the memory module with the tab on the slot and slide the memory into the slot at an angle.
Press the memory module down until it clicks into place.
Base Cover
Identify the base cover location highlighted in blue.
Align the base cover tabs to the slots, press the cover until it clicks into place.
Tighten the screws to secure the base cover to the chassis.