This 3D experience gives you the step by step process of replacing the Solid State Drive (SSD) 2230 on a Optiplex Micro 3090. The procedure will also include removing the Side Cover, Hard Drive Assembly 2.5 inch and reinstalling them.
Removal
Side Cover
- Identify the side cover highlighted in blue.
- Loosen the thumb screw that secures the side cover to the system.
- Slide and lift the side cover off the system.
Hard Drive Assembly 2.5 inch
- Identify the hard drive assembly highlighted in blue.
- Press the release tabs on the hard drive assembly and slide it towards the front of the system.
- Lift the hard drive assembly from the system.
Solid State Drive (SSD) 2230
- Identify the solid state drive (SSD) highlighted in blue.
- Remove the screw that secures the SSD to the system board.
- Slide and lift the SSD from the system board.
Install
Solid State Drive (SSD) 2230
- Identify the solid state drive (SSD) location highlighted in blue.
- Align the notch with the tab and slide the SSD to its connector on the system board.
- Install the screw that secures the SSD to the system board.
Hard Drive Assembly 2.5 inch
- Identify the hard drive assembly location highlighted in blue.
- Place the hard drive assembly into the slot on the system.
- Slide the hard drive assembly towards the connector on the system board until the release tabs click into place.
Side Cover
- Identify the side cover location highlighted in blue.
- Place and slide the side cover towards the back of the system.
- Tighten the thumb screw that secure the side cover to the system.