Removal
Base Cover
Identify the base cover highlighted in blue.
Loosen the captive screws that secure the base cover.
Pry the base cover near the hinges to release it from the system.
Remove the base cover by loosening the sides and front.
Battery Cable
Identify the battery cable highlighted in blue.
Using the pull tab, lift up to disconnect the battery cable from the system board.
Press and hold the power button for 10 seconds to ground the system and remove residual static electricity.
Battery
Identify the battery highlighted in blue.
Loosen the captive screws that secure the battery.
Lift the battery out of the system.
Turn the battery over.
Peel the tapes that adheres the battery cable to the battery.
Remove the battery cable from the routing guides on the battery.
Disconnect the battery cable from the connector on the battery.
Remove the battery cable away from the battery.
Wireless Module (WLAN)
Identify the wireless module (WLAN) highlighted in blue.
Loosen the captive screw that secures the WLAN card bracket.
Remove the bracket to access the WLAN cables.
Disconnect the antenna cables (black and white cables) from the WLAN.
Slide and remove the WLAN card from the connector.
Wireless Module (WWAN)
Chassis Frame
Identify the chassis frame highlighted in blue.
Disconnect the speaker cable from the system board.
Unroute the speaker cable from the chassis frame.
Disconnect the fan cable from the connector on the system board.
Remove the fan cable from the routing guides.
Loosen the screw that secures the chassis frame and optional fingerprint bracket.
Remove the screws that secure the chassis frame to the system.
Lift to remove the chassis frame.
Smart card module
Identify the smart card module highlighted in blue.
Lift latch and disconnect the smart card cable from the USH board.
Remove the screws that secure the smart card module to the system.
Lift the smart card module and the cable from the system.
Install
Smart card module
Identify the smart card module location highlighted in blue.
Install the smart card module into the slot to align with the tabs on the system.
Install the screws to secure the smart card module to the system.
Connect the smart card cable to the USH board. Close the latch to secure it.
Chassis Frame
Identify the chassis frame location highlighted in blue.
Align and place the chassis frame on the system chassis.
Install the screws to secure the chassis frame to the system.
Tighten the screw that secures the chassis frame and optional fingerprint bracket.
Route the fan cable through the routing guides.
Connect the fan cable to the connector on the system board.
Route the speaker cable along the chassis frame.
Connect the speaker cable to the system board.
Wireless Module (WWAN)
Wireless Module (WLAN)
Identify the wireless module (WLAN) location highlighted in blue.
Insert the WLAN into the connector on the system board.
Connect the black cable to the auxiliary (black triangle).
Connect the white cable to the main (white triangle).
Install the bracket to secure the antenna cables.
Tighten the captive screw to secure the WLAN card bracket.
Battery
Identify the battery location highlighted in blue.
Connect the battery cable to the connector on the battery.
Route the battery cable through the routing guides on the battery.
Adhere the tapes that secures the battery cable to the battery.
Turn the battery over.
Install the battery into the slot on the system, aligning the screw holes.
Tighten the captive screws to secure the battery in place.
Battery Cable
Identify the battery cable location highlighted in blue.
Push down to connect the battery cable to the connector on the system board.
Base Cover
Identify the base cover location highlighted in blue.
Align the base cover tabs to the slots, press the cover until it clicks into place.
Tighten the captive screws that secure the base cover to the system.