Removal
Base Cover
Identify the base cover highlighted in blue.
Loosen the captive screws that secure the base cover.
Pry the base cover near the hinges to release it from the system.
Remove the base cover by loosening the sides and front.
Battery Cable
Identify the battery cable highlighted in blue.
Using the pull tab, lift up to disconnect the battery cable from the system board.
Press and hold the power button for 10 seconds to ground the system and remove residual static electricity.
Wireless Module (WLAN)
Identify the wireless module (WLAN) highlighted in blue.
Loosen the captive screw that secures the WLAN card bracket.
Remove the bracket to access the WLAN cables.
Disconnect the antenna cables (black and white cables) from the WLAN.
Slide and remove the WLAN card from the connector.
Wireless Module (WWAN)
Display Cables
Identify the display cables highlighted in blue.
Remove the screws that secure the eDP bracket to the system board.
Lift the display/eDP bracket away from the system.
Disconnect the display cable from the connector on the system board.
Remove the display cable from the routing guide.
Display Assembly
Identify the display assembly highlighted in blue.
Remove the screws that secures the display assembly to the system chassis.
Lift the palmrest up and slide out to remove off the display assembly.
Install
Display Assembly
Place the display assembly on a flat surface.
Identify the display assembly location highlighted in blue.
Install the palm rest assembly on the display assembly and align the hinges.
Install the screws that secure the display assembly to the system chassis.
Display Cables
Identify the display cables location highlighted in blue.
Route the display cable through the routing guide.
Connect the display cable to the system board.
Install the eDP cable support bracket to the system.
Install the screws to secure the eDP bracket to the system board.
Wireless Module (WWAN)
Wireless Module (WLAN)
Identify the wireless module (WLAN) location highlighted in blue.
Insert the WLAN into the connector on the system board.
Connect the black cable to the auxiliary (black triangle).
Connect the white cable to the main (white triangle).
Install the bracket to secure the antenna cables.
Tighten the captive screw to secure the WLAN card bracket.
Battery Cable
Identify the battery cable location highlighted in blue.
Push down to connect the battery cable to the connector on the system board.
Base Cover
Identify the base cover location highlighted in blue.
Align the base cover tabs to the slots, press the cover until it clicks into place.
Tighten the captive screws that secure the base cover to the system.