Removal
Base Cover
Identify the base cover highlighted in blue.
Using a Torx #5, remove the screws that secure the base cover.
Starting at the bottom left corner, carefully pry the base cover along the bottom and sides.
Grasp the bottom and rotate it upwards to release the base cover from the system.
Battery Cable
Identify the battery cable highlighted in blue
Use the tab to assist in disconnecting the battery cable from the system board.
Press and hold the power button for 10 seconds to ground the system and remove residual static electricity.
Memory Modules
Identify the memory module highlighted in blue.
Peel the bottom of the DDR jacket back to access the memory module.
Using your fingertips, carefully spread apart the securing clips until the memory module pops up.
Slide the DDR jacket off to remove from the memory module.
Slide and remove the memory module from the memory module slot.
Install
Memory Modules
Identify the memory module location highlighted in blue.
Align the notch on the memory module with the tab on the slot and slide the memory into the slot at an angle.
Slide the DDR jacket over the memory module.
Press the memory module down until it clicks into place.
Adhere the bottom of the DDR jacket to the memory holder.
Battery Cable
Identify the battery cable location highlighted in blue.
Connect the battery cable to the system board.
Base Cover
Identify the base cover location highlighted in blue
Align and install hinge first (careful of the cable inside the cover). Press until it clicks into place.
Install the screws that secure the base cover. (requires Torx #5)