Removal
System Cover
Identify the system cover highlighted in blue.
Turn the latch release lock to the unlocked position.
Press the cover release latch and remove the system cover.
Front Bezel
Identify the front bezel highlighted in blue
Unlock the front bezel by using the key.
Press the release latch at the top of the bezel.
Pull the top end of the bezel away from the system.
Unhook the bezel tabs from the slots at the bottom of the system, and pull the bezel away from the system.
Drive carrier
Select the drive carrier you want to replace
Press the release button to open the release handle.
Holding the handle, slide the drive carrier out of the drive slot.
Air shroud
Position the System as shown in video.
Identify the air shroud highlighted in blue
Holding the touch points at the center of the air shroud, lift the shroud from the system.
Backplane
Identify the hard drive backplane highlighted in blue
Disconnect the data, signal, and power cables from the backplane.
Press the SAS connector and push the connector toward the top of the system to release the SAS cable from the backplane.
Pull the release pin and holding the pin, lift the backplane out of the system.
Install
Backplane
Identify the hard drive backplane location highlighted in blue
Use the hooks at the base of the system as guides to align the hard drive backplane.
Lower the hard-drive backplane into the system till the release pin locks in place, securing the hard drive backplane to the
Connect the data, signal, and power cables to the backplane.
Air shroud
Identify the cooling shroud location highlighted in blue
Align the tabs on the air shroud with the securing slots on the chassis.
Lower the air shroud into the chassis until it is firmly seated.
Position the System as shown in video.
Drive carrier
Confirm the drive carrier you want to replace
Press the release button on the front of the drive carrier to open the release handle.
Insert the drive carrier into the slot and slide until it connects with the backplane.
Close the drive carrier release handle to lock the drive in place.
Front Bezel
Identify the front bezel location highlighted in blue
Insert the bezel tabs into the slots in the chassis.
Press the release latch, and push the bezel toward the system until the bezel locks into place.
Using the key lock the bezel.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the slots on the chassis.
Rotate the latch release lock clockwise to the locked position.